Path Settings for Slave terminals

Moderators: Mike Gooch, Jon Rogan, Ankit, Michael Morris

Post Reply
Michael Morris
Posts: 38
Joined: Fri Oct 05, 2018 11:57 am

Path Settings for Slave terminals

Post by Michael Morris »

Path Settings for slaves

Go into Paths in the back office settings
1.png
1.png (57.9 KiB) Viewed 31462 times

• Make sure the Master Touch folder is shared with full read/write permissions
• Select the Slave option as highlighted above (this is the same procedure as for a slave terminal)
• Enter the PC name for the Master Till (or PC that is acting as the Master) into the top box ‘Master Touch folder: Example as shown above ‘C:\ has been replaced with \\TILL01\
• Press the Save button at the bottom of the screen
• If the path setting is good and the Master Touch folder can be located the path settings will be saved and the screen will close
• If there is an issue with the network path to connect to the Master Touch folder the message below will show and the path settings will not be updated.
2.png
2.png (14.94 KiB) Viewed 31462 times
Post Reply