Standalone Mode IT'S BACK!

Moderators: Mike Gooch, Jon Rogan, Ankit, Michael Morris

Post Reply
Admin
Site Admin
Posts: 7
Joined: Fri Oct 05, 2018 10:09 am

Standalone Mode IT'S BACK!

Post by Admin »

UNC Standalone mode for slave tills when the master is not available has been ported over from v8.8 with several improvements added. Standalone mode previously known as UNC in older versions of Touch has been reintroduced to Touch v9.1.017. This is to allow slave terminals to work with basic functionality if the master is unavailable.

Tis document outlines the single step needed to enable or disable it.

Glad to see it back.
Attachments
Touch v9.1 Standalone Mode.pdf
(763.2 KiB) Downloaded 1784 times
Post Reply