Path Settings for slaves
Go into Paths in the back office settings
• Make sure the Master Touch folder is shared with full read/write permissions
• Select the Slave option as highlighted above (this is the same procedure as for a slave terminal)
• Enter the PC name for the Master Till (or PC that is acting as the Master) into the top box ‘Master Touch folder: Example as shown above ‘C:\ has been replaced with \\TILL01\
• Press the Save button at the bottom of the screen
• If the path setting is good and the Master Touch folder can be located the path settings will be saved and the screen will close
• If there is an issue with the network path to connect to the Master Touch folder the message below will show and the path settings will not be updated.
Path Settings for Slave terminals
Moderators: Mike Gooch, Jon Rogan, Ankit, Michael Morris